You are here

Home

Release Agent

Film Release Agent PVA

Release agent for epoxy and polyester resin with max curing temperatures of 100°C Silicone-free. Any residue in the mould and on the component dissolves in water and is simply washed off. One coat of PVA is applied after each and every de-moulding.

Priming Wax release agent

 Apply the Priming Wax to the mould surface, after 3 minutes rub gently with a soft cotton cloth to remove straie caused by uneven thick application.

Repeat 3 to 5 times then leave in a warm room for the solvents to evaporate for 12 hours.

Quick Release Agent

Apply the Quick Release Agent to the clean / new moulds with a cloth or brush and leave to dry which can take up to 45 minutes depending on the temperature before laying up on the mould.

This product is water based and environmentally friendly.
Subscribe to Release Agent

© Copyright Bucks-Composites, all rights reserved.