You are here

Bucks 8 metre Single-Part Coating Kit for model Boats & model Planes

The perfect solution for strengthening foam models.

Not fuel proof.

Pack includes:

  • Two lots of 4 metre long x 1.1 metre wide of 25g Ultra Lightweight Glass Fibre Woven cloth.
    Two lots of 4 metre long x 1.1 metre wide of 49g Super Lightweight Glass Fibre Woven Cloth.
  • Two lots of 500ml of Bucks Single-Part Coating System (Gloss or Semi-Matt Finish).
  • 1 Bucks Synthetic Coating Brush 1"
  • 1 Bucks Synthetic Coating Brush 2"
  • 2 coating Squeegee applicator card.
  • 1 150ml Pot.
  • 2 pairs of Surgical Gloves.
  • Instructions.

Foam Friendly, single-part no mixing required, dries hard & clear.

Self Levelling Properties and very long working time.

Not fuel proof.

Acrylic paint ok.

Cellulose paint not suitable.


Makes a good ding resistance surface on models.

Full strength is in 4 weeks.

Low Odour & easy to use.

Shake bottle before use.

If covering a foam surface, sand the foam smooth then cut the glass fibre woven cloth to size and lay on the foam surface then wet the cloth with the single-part coating system with a Bucks coating brush then leave for 2 hours to dry before applying a further three coats allowing 2 hours drying time between coats.

The brush when used with Bucks Single-Part Coating System can be easily cleaned with warm soapy water.

Please select glass fibre woven cloth weights: 25g (1.1 metre wide) or 49g (1.1 metre wide) & finish from the menu below.


© Copyright Bucks-Composites, all rights reserved.