You are here

Bucks Formula 50 Laminating Epoxy Resin with Hardener (24 hour cure time)

Note: Please contact us by phone if you require resin.

For impregnating Aramid / Kevlar®, Glass Fibre & Carbon Fibre. Low viscosity

Also very good for wetting out very lightweight glass fibre cloth on model boats and aircraft from sealing coat to surface finishing.

Great for bonding wood, metal, foam, polystyrene, etc.

Also totally fuel proof once cured.

 

The resin and hardener pack comes with 2 mixing pots and 2 spatula's. Spare hardener can also be ordered.

Please follow the link below for covering a model plane or model boat:-

Guide to Surface Finishing

Easy measuring ratio.

Mix ratio by weight: 100 parts Resin to 40 parts Hardener (2.5 to 1)

Mix ratio by volume: 100 parts Resin to 50 parts Hardener (2 to 1)

 

300g resin & 120g hardener- net weight combined 420g

600g resin & 240g hardener- net weight combined 840g

 

Notes:

Take into consideration heat generation when mixing resin and hardener, once mixed put into a larger area this will prevent higher temperature build up and this will give you a longer pot life (working time). Never mix large quantity of resin and hardener.

  • Full depth cure / Pot life 50mins / Cure time 24 hours.
  • Leave to cure at room temperature for 24 hours
  • Winter time, always leave the Epoxy Resin and Hardener in a warm area to cure for 24 hours and never turn the heating off during winter time while the curing is taking place.

Also Foam Friendly.

See our Resin & Additives Tips page, which has a downloadable mixing chart for you to print for easy reference.

Amount: 
420g
£12.50

© Copyright Bucks-Composites, all rights reserved.